I have configured a UC320W to work with my mediatrix box 4404 and was giving the users a demo of how there phones work, which are mainly SPA504G's. I have noticed that when a call comes in the numbers on the display are missing the first 0, e.g. if someone calls in from 0131 123 4567 it appears on the phone as 1311234567. At first I did not see this a real problem as it is just the display, however if you try to use the redial or missed call functions the numbers dont work, due to the missing "0" and I assume the fact that there should be a "9" at the start for an outside line.
I beleive someone has already started a thread about the number of digits in a number, i.e. the fact that the UC320W offers a six digit or eight digit dialing plan, and the uk also has a seven digit, for example we are in edinburgh and the numbers are 0131 xxx xxxx. I have picked six digits so am not sure if this is possbly the cause of my issues.
If someone could tell me what I need to change I would appreciate it.
I now have this resolved on my setup for our new office, the SIP provider (Gamma Telecom) were able to put the 0 back onto the incoming phone numbers themselves, Maybe you need to contact your service provider also.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...