Once into the telephony-service I am not positive on the syntax required to give me that output. I have tried 'show' timezone, but that is an invalid command in this section. How would I be able to display the information?
So it has been a while, but I am back on this now. And as it stands, the 4-7911's are now all off 5 hours. Current local time is 12:09PM EST, and the 7911's all display 5:10PM. Per the last post, here is the info Steve requested.
UC520#show run | inc time service timestamps debug datetime msec localtime service timestamps log datetime msec localtime clock timezone EDT -5 clock summer-time EDT recurring
I also ran a:
UC520#show telephony-service CONFIG (Version=7.1)
timezone 0 Greenwich Standard Time
The timezone definitely explains the 5 hour difference, but: A.) How do I change it, and B.) Why is it only affecting the 7911's and not the rest of the phones. Do I also need to setup the Summer-Time in the Telephony-Service?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...