I am trying to upgrade the load for one phone connected to a UC520. I do not want to load the entire software pack at this time. I went to phone load management in CCA. I deleted the current load for that model. I uploaded the new version from the 8.1 software pack. I rebooted the phone and it does not upgrade. It is still has the old load. Also, I telnetted to the box and removed and created the CNF files. What am I missing?
What type of switch do you have the phones plugged into? Sounds like trunking is not set up properly to allow VLAN100 traffic on that switch.You may want to check the Smart Port Role for the expansion port on the UC and make sure it is set for switch and make sure all vlans are added.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...