05-05-2013 01:37 AM - edited 03-21-2019 07:19 AM
I'd like to recover connectivity with CUE.
I deleted default static routing setting 10.1.10.1 for CUE by my mistake.
I tried to configure like followings.
---
UC520#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
UC520(config)#interface Loopback0
UC520(config-if)#description $FW_INSIDE$
UC520(config-if)#ip address 10.1.10.2 255.255.255.252
% 10.1.10.0 overlaps with Vlan101
UC520(config-if)#ip access-group 101 in
UC520(config-if)#ip nat inside
UC520(config-if)#ip virtual-reassembly
UC520(config-if)#interface Integrated-Service-Engine0/0
UC520(config-if)#description cue is initialized with default IMAP group
UC520(config-if)#ip unnumbered Loopback0
UC520(config-if)#ip nat inside
UC520(config-if)#ip virtual-reassembly
UC520(config-if)#service-module ip address 10.1.10.1 255.255.255.252
Need IP address to be configured on interface Integrated-Service-Engine0/0
---
It seems like ip adress setting failed because of overlapping with Vlan101. Also CUE Connectivity Diagnostics says "IP address needs to be configured on interface Integrated-Service-Engine0/0"
---
Use reset only to recover from shutdown or failed state
Warning: May lose data on the the NVRAM, nonvolatile file system or unsaved configuration!
Do you want to reset?[confirm]
Trying to reload Service Module Integrated-Service-Engine0/0.
UC520#service-module Integrated-Service-Engine 0/0 session
IP address needs to be configured on interface Integrated-Service-Engine0/0
UC520#
---
I'm a beginer of IOS, Cisco products and also English. I can barely use CCA. Thank you.
Solved! Go to Solution.
05-05-2013 01:38 PM
Check in flash there should be a default configuration file with basic settings.
05-05-2013 01:38 PM
Check in flash there should be a default configuration file with basic settings.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: