I have a remote teleworker that is connecting to our UC520 back at the office. The remote teleworker setup includes an SR520W at the remote site with an SPA525G phone sitting behind it. The remote teleworker is accessing our server and some other applications on our corporate LAN while connected. Is there any way to set up a second VLAN (or use the wireless VLAN solely) for non-VPN traffic? I am already using split tunneling, but the remote teleworker will often have vendors and other parties coming into his office with a need for Internet Access and I'd like to separate traffic for obvious security reasons.
I'm going to play around with that later today to see what happens. I'm still a little bit concerned that the although we could put 1 port on VLAN 1 and another port on VLAN 50 (i.e. guest) that their traffic would still hit our server if they knew what to look for. That might be a stretch, but it's a security concern at the very least. Is there any way to ensure that the only traffic from VLAN 1 travels over the VPN but all traffic from VLAN 50 cannot?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...