Simple FXS port no access digit dialing (for Fax and EFTPOS)
There may be several ways to do this, but with some assistance for the big C guys (cheers Luke and Dave) here is a simple solution for no access digit dialing for FXS ports. (that is, can dial the number directly without using 0 or 9 to select 'outside line')
Because the FXS port is a skinny controlled port, we apply a translation profile to the ephone-dn for the port to add the access digit (in our case 0)
So, create the translation rule and profile
voice translation-rule 10001
rule 1 // /0/
voice translaton-profile FXS_FAX_EFTPOS
translate called 10001
Then, on ephone-dn 5 (if that is the port you are using, ephone-dn5 is 0/0/0 of the fxs for this example)
add the translation profile to the port
translation-profile incoming FXS_FAX_EFTPOS
So now when dialing out on this port, the leading 0 for outside number does not need to be added. However you cannot dial internally from this port. (generally not an issue on a fax or eftpos terminal)
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...