SPA504G - CBE6K

[hfsitmat-17]

Hey..

Anybody knows if small business phones like SPA504G is supported on cucm 9.0 in BE6000..?

- Casper Fogh

[Rob Huffman · Accepted solution]

Hi Casper,

Listed below are the supported models

Cisco Unified IP Phone 3900 Series:

http://www.cisco.com/en/US/products/ps7193/tsd_products_support_general_information.html

Cisco Unified IP Phone 6900 Series:

http://www.cisco.com/en/US/products/ps10326/tsd_products_support_general_information.html

Cisco Unified IP Phone 7900 Series:

http://www.cisco.com/en/US/products/hw/phones/ps379/tsd_products_support_general_information.ht

ml

Cisco Unified IP Phone 8900 Series:

http://cisco.com/en/US/products/ps10451/tsd_products_support_general_information.html

Cisco Unified IP Phone 9900 Series:

http://cisco.com/en/US/products/ps10453/tsd_products_support_general_information.html

From;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucmbe/docguide/8_6_1/dg861be.pdf

You will also see this note from the CUCM/FAQ's

Is it possible to register SPA 500 AND SPA 300 SERIES IP PHONES with CUCM ?

Natively SPA500 and 300 are not supported in CUCM. These phones supports standard SIP and SPCP (Tokenized Skinny), not SCCP.

These  Phones are designed/tested with  UC500 only. SPA5xx will interoperate  with CUCM in SIP mode for basic features (i.e. make/receive calls, call  forward, transfer and conferencing.) Other features may not work  properly.

https://supportforums.cisco.com/docs/DOC-13450#Is_it_possible_to_register_SPA_500_AND_SPA_300_SERIES_IP_PHONES_with_CUCM_

Cheers!

Rob

"Clocks go slow in a place of work
Minutes drag and the hours jerk" 

-The Clash

[hfsitmat-17]

Thanks alot..

Have a nice weekend..

-Casper

[CipherunaSupport]

Thanks a lot Rob,

If these phones are configured as SIP phones. What are the limitations that come with SIP phones?

The only requirement I have is to add these phones in a call blast group and have dual lines. That's it. Can this be achieved?