Recently my company made the switch from standard phone lines to IP phones, and we loved the idea that all the settings and personalizations were set via phone, rather than via line. Since it was my job to figure out all the cool new features, I did a few test settings with my phone and my boss's phone. I figured out how to log in and change the line key buttons to be direct dial buttons, and everything was fine.
Then we had some internet problems and the phones lost power. After booting them back up, I noticed that while the keys still dialed the correct numbers, the "Short Name" labels all had reset. Is there any way to prevent this from happening? I'd hate to have to set up 25 phones with their own custom labels and settings, just to have to go through and fix them off if we lose internet or power briefly (which happens a lot due to all the construction in our office park area).
Any suggestions are appreciated! Thanks in advance,
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...