I need to setup a SPA525G with a UC560 implementation at a customer's remote site. The issue is the remote office is way out there and need to find a way to set it up manually. Looking for step by step manual directions for this.
Follow the steps in the TEL lab that steve wrote aside from the Phone VPN wizard. From the phone itself go to settings > network configuration > VPN and you might be able to just follow what I entered in the picture along with the settings you entered from the SSL VPN configuration page. The group name should be left blank it is not a valid field.
So in short you will be creating the SSL VPN and then entering those settings into the phone manually.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...