I have a situation where I'm running firmware version 7.5.3 and need to change from an "Asterisk" Server Type to a "RFC3265_4235" per the PBX manufacturer's recommendation. The PBX manufacturer is not supporting firmware version 7.5.4 and cannot upgrade to it yet. However there is an issue listed as being resolved in version 7.5.4 with the RFC3265_4235 server type and so I'm assuming this issue exists in 7.5.3.
When a line key on the phone is programmed as a busy
lamp field, and there is a mismatch between the subscribed
URI and the speed dial extension URI, the phone does not
respond to NOTIFY messages to change the LED status.
This occurs when the server type is set to RFC3265_4235.
I'm hoping to get a better idea of what exactly the "subscribed URI" and the "speed dial extension URI" are, so that I can determine if they're mismatched and if I will be introducing a problem when changing server types.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...