I have multiple SPA525G2 devices deployed, some with the attendant console attached. I am running in SIP mode w/Asterisk, SW 7.4.9c. For physical extensions w/BLF I use the following function:
In this case BLF works and I can perform a 1-button transfer (e.g. if I want to transfer the active party to ext. 9000 I simply press the button on the console). I also have buttons setup to transfer to voicemail which is accessed by *+<extID>. In this case I only use the speed dial function:
If I attempt to perform a 1-button transfer here the current call is placed on hold and I am connected to the users VM box. What causes the speed dial/1-button transfer behavior to differ between these two entries? Is there some way to get the behavior I'm looking for? Thanks.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...