I've searched the Cisco Web site and documentation and can't find any information or specifications for what I can connect to the MoH port. I have a Digital Messaging System with both a 600 ohm and an 8 ohm output. Which should I use to connect to the MoH port?
2. When impendence does it have? Is it 8 ohms or 600 ohms or something else?
- If I plug in the incorrect impendence source it will not work correctly. Worst case i will 'short' the UC Mother board and burn it out. or the MoH source output amp. Best case it just won't work correctly.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...