Specify fxo for outbound calls depending on which ephone-dn used
Hey community members,
Let's say I have 3 companies behind my UC500. Each company owns 4 POTS lines from carrier.
Company 1's POTs are connected into FXO 0/1/0 - 0/1/3
Company 2's POTs are connected into FXO 0/2/0 - 0/2/3
Company 3's POTs are connected into FXO 0/3/0 - 0/3/3
For inbound calls, I simply created octo-dns called Main for each company and did a connection plar on each voice-port to the respective octo-dns. All phones will have their one internal extension dn and sharing the Main dn for their company.
For outbound calls, how do I make sure that if a Company 1 user picks up his phone on his internal extension dn to dial outside, his calls will use FXO 0/1/0 - 0/1/3? and Company 2's outbound calls to use 0/2/0 - 0/2/3? and Company 3 to use 0/3/0 - 0/3/3?
That doc should give you a good reference. Instead of doing it by local, long distance and international, you will have to also include which port will be getting used by applying the correct config on the dial-peer as well. Does that make sense?
Re: Specify fxo for outbound calls depending on which ephone-dn
Steve & Marcos
I've seen both documents and noticed that one document has corlist incoming for dial-peer and corlist outgoing for ephone-dn and the other document has it reversed. To achieve what I am trying to do, which is the correct config? I believe I tried both but most likely do not have it correctly configured. I am playing around with it more right now.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...