On the SPA-932 (attached to an SPA-962), is there any guide to configuring the keys to perform a speed dial with a delay?
I am trying to set a key to perform a transfer which requires dialing # and then a number. It is going to park a call so the extension is pre-known, but when I tried setting the key to fnc=sd;sub=#700@pbx-ip-here it never performed the transfer. It appears the digits are transmitted to rapidly that the 700 happens before the transfer process initiates so it never transfers.
Is there a way anyone else has done something like this or has been able to get this to work? This is an Asterisk PBX for what its worth.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...