Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Transfer button grayed out on 7931

UC520 software pack 8.1.0 recently reloaded with CCA 3.0. FXO PSTN connectivity using CO Lines on each phone.

When a call comes in and is picked up on a CO Line, the call is not able to be transferred using the Transfer soft button (it's grayed out), but it can be done by pressing the transfer key (on a 7931) and dialing the users extension. Also, they are unable to just press a "watched" extension button to transfer the call, they have to manually dial the extension number.

I have similar setup in our office here and have the buttons available, but we are running an older software pack loaded with an older version CCA (2.2 I believe).

Anyone know why this is happening?


Thanks,

Derek

Everyone's tags (5)
10 REPLIES
Community Member

Re: Transfer button grayed out on 7931

Also, the redial softkey is grayed out as well.


Thanks,


Derek

Re: Transfer button grayed out on 7931

Derek,

Do me a flavor :-)

Make a call from the 7931.  Then see if the Redial comes back for use.

Community Member

Re: Transfer button grayed out on 7931

OK, I'll try that. I am just going by what the customer is complaining about so I will need to go onsite and see what it does then update this post.

Thanks,


Derek

Community Member

Re: Transfer button grayed out on 7931

The phone on my desk does the same thing, it's a 7970G. I make a call, internal or external, hang up, and the redial button remains grayed out. Not sure if something is configured incorrectly or not?

Re: Transfer button grayed out on 7931

I asked because mine always starts grey until I make a call, then it comes to life.

Is this a CLI configured system or CCA?

Community Member

Re: Transfer button grayed out on 7931

This system was configured using CCA 3.0.

Community Member

Re: Transfer button grayed out on 7931

When I press the redial soft button on my 7970 it says "that key is not active here".

Re: Transfer button grayed out on 7931

Hmmmm...  strange and not normal.  I have a 7931 and it works on my UC 500 with latest SWP and

CCA.

Please open a case.

Community Member

Re: Transfer button grayed out on 7931

OK, will do. I will update the post with the solution.

Thanks!

Derek

Community Member

Re: Transfer button grayed out on 7931

Derek,

Did they have a resolution for you regarding this?

I also have the same issue with Transfer button.

Dave

2203
Views
0
Helpful
10
Replies
CreatePlease to create content