Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Transfers on SPA-932

Hello,

When using a SPA-932 attached to an SPA-962, I am trying to figure out how to perform a transfer on an Asterisk PBX. I have tried setting fnc=sd;sub=#700@asterisk-ip on one of the line keys where # is the transfer key and 700 is the extension to transfer to (call park).  However when the button is pressed, it happens so quickly that the transfer doesn't register past the # digit, resulting in a failed transfer.

Is there a way to introduce a delay here or does anyone have any other suggestions on how to achieve one button call parking with this setup and Asterisk?

Thanks in advance!

1 REPLY
VIP Gold

Transfers on SPA-932

If I understand correctly, you are wishing to insert a pause between # and 700.

Unfortunatelly, no goot news for you. It is possible on SPA[35]xx phones starting with 7.5.1 firmware, but I suspect the SPA9xx is so old to support it.

As a very dirty hack, you can change string to something like

sub=#0000000000000000000000700

then modify Asterisk's extension conf to ignore all but last three digits.

247
Views
0
Helpful
1
Replies
CreatePlease to create content