I have a site with main office and 2 users at a remote site connected by a high speed wan. I would like to add a couple of phones there and get them to connect to the UC320.
Does anyone know if this is possible? Without trying I'm not sure how to get the routing working, as I don't think I can connect a phone via the WAN interface, and there is no way to add routes to the LAN interface side is there?
Also what would be required for dhcp to tell the phone where the UC320 is?
Have seen a post before on this subject, but it woudl be good if this device had the option of running in appliance mode (without WAN).
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...