My SIP provider needs a user id prefix attached to outbound calls in the form 99999999# in order to use static IP based verification. They use the user id prefix to lookup whether the outbound IP address is allowed.
How can I prepend an 8 digit number and '#' to my ourbound calls?
Per the SIP provider's website:
You will need to prefix your outbound calls with this user id order to authenticate your account for outbound calls from the IP specified previously.
For most systems you will need to setup a dialplan to add your user id on outbound calls. If you are not sure how to do this, please contact your PBX vendor.
Thanks Wendy, the UC320w can provide SIP credentials rather than static IP based authentication so I will go with that.
1) Does the UC540 allow for a custom dial plan?
2) I would like to get ahold of administration guide for the UC540 but I can't seem to find one. It would be nice to have one because the sales brochures never really give you the nuts and bolts of how the devices work so you get halfway through an install and realize you can't do what you need to do.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...