Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

UC320W - Doesn´t send ext. as CLID

Hi all,

maybe somebody can help me. I installed a UC320W. Only a SIP Trunk is used as line.

Everything works fine except CLID

If you call outside, on the called phone only the no. without ext. is showed.

SIP provider checked his logfiles - he receives only no without extension.

I am useing PBX mode - but I tried mixed also.

Please help.

Best regards

Marcus Plessl

Everyone's tags (5)
2 REPLIES
Community Member

UC320W - Doesn´t send ext. as CLID

Hi Marcus,

Do you have the DIDs configured for each Extension on the Inbound Routes page like this? (Click image to enlarge)

Chris

Community Member

UC320W - Doesn´t send ext. as CLID

Hi Chris,

No, I had no route for each extension. I only had one incoming route which lead to a collect extension (0)

Now I tried as suggested inbound routing like you can see in picture.

Unfortunately then this extensions are not able to call outbound any longer.

If I try I get busy signal instant.

Also I noticed that Inbound Routing leads to every call is going to collect extesion 0 even if it is dialed ext. 13 for example which is not in collect ext.

Best regards

Marcus

365
Views
0
Helpful
2
Replies
CreatePlease to create content