I have a user who, about 50% of the time when she receives an outside call, callers are unable to navigate through the AA. Press the tones does nothing to the AA, it just keeps on playing. Then i could hang up, call right back and then the AA acknowledges my key entries without fail. Any one have any clues about this? System was working up until about 3 days ago. Only thing we did was staples a CAT5 cable to the wall. No other changes have been made, and I am almost 100% sure that didn't cause it. I checked all the seetings and reloaded the system a few times - still no luck. Any suggestions welcomed.
If the symptom presented itself after stapling the cat 5 to the wall you may just want to run a check on the cable to make sure the staple did not pierce the casing. Additionally if the calls are coming in over FXO ports you could run the impedance testing on the line to verify that they are set correctly.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...