My question is in regards to BLF behavior on the SPA500 series phones running firmware version 7.4.3.
The phones are registered to the UC560 via SCCP.
When BLF is configured via CCA 2.2.4 for WATCH or MONITOR, the tri-color buttons are un-lit when the watched/monitored line/phone is not in use. When the watched/monitored line/phone goes off-hook the tri-color button displays red.
Can SPA phones (fw ver. 7.4.3) registered to the UC560 (8.0.2) via SCCP have their tri-color buttons do the following?
Be GREEN = line is registered. (This includes the phone's own lines)
Be ORANGE = watched/monitored line registation error
Be blinking RED = watched/monitored line ringing
Be solid RED = watched/monitored line in use
NOTE: This requested behavior matches SPA500 phones running 7.4.4 and SIP registered to 3rd party Softswitch.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...