Upgraded UC500 to 7.0.3, factory default settings. Receive the following error when attempting to open the Voice configuration "Error:Voice Cannot open Connection" system counts down, progress bar stops, and never opens up Voice settings.
No other issues, I can login to the CME via http and open all other configuration utilities. Service-Engine is running, I reset again to factory default and ran the setup wizard successfully via CCA 2.0 and received the same error when opening Configuration|Voice
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...