07-28-2009 08:57 AM - last edited on 03-25-2019 10:40 PM by ciscomoderator
I searched this site, UC500.com, and cisco for any installation guides setting up a Qwest PRI circuit on the UC500, and specifically on the VWIC2-1MFT-T1/E1=
We're always doing Cbeyond SIP circuits and now we have a Qwest PRI circuit.
Does anyone have the set up guide/seps /procedure for this card on the UC500 ?
I'd love any guides, advice, look out for these gotchas, etc
Thanks!
Stacy
Solved! Go to Solution.
07-28-2009 08:59 AM
Hi Stacy,
I´ve found that the setup is easy using CCA. The one thing I ended up struggling with was a CRC setting from the telco. Other than that it was "a walk in the park" (is that the correct term?!
)Regards
Eivind
You can take a look at my post when I setup my first UC with a VWIC card;
https://www.myciscocommunity.com/message/8911
Message was edited by: Eivind Jonassen
07-28-2009 09:36 AM
07-28-2009 08:59 AM
Hi Stacy,
I´ve found that the setup is easy using CCA. The one thing I ended up struggling with was a CRC setting from the telco. Other than that it was "a walk in the park" (is that the correct term?!
)Regards
Eivind
You can take a look at my post when I setup my first UC with a VWIC card;
https://www.myciscocommunity.com/message/8911
Message was edited by: Eivind Jonassen
07-28-2009 09:36 AM
Stacy,
Eivind is correct. CCA should get you there.
Thanks,
Marcos
07-28-2009 10:41 AM
Thank you for your help !!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: