I have a question, in the AA, suddenly when you call in to the company, we are unable to select the call tree in the AA. Like 1 or 2 and so on. This is inbound. I have seen this before years ago. I forgot the fix for this. It was working before all the new upates on the old AA. It may be the dial-peer lacking dtmf-relay setting. But I am not familiar with these settings. I have attached my Running Config.
Also, after save configurations and restarting the UC520, Site to Site VPN is up and operational. But now AnyConnect Client will not connect to the UC520. Any thoughts?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...