I have enabled night service to use a floating extension that redirects to an answering service. I have tested the floating extension by dialing it to confirm that it does redirect to the answering service.
I have setup my schedule for business and night hours. I have *2102 to toggle night service on and off. My inbound lines are configured to answer to a hunt group.
The problem is when I enable the night service by toggling it on and try to attempt to dial a number on the uc500 from my cell phone it never triggers the night service instead it is going to my hunt group. I realize I may need to provide more information will post more in the morning.
I followed a post from http://uc500.com/hunt-groups-and-night-service and now it works I had to setup a ephone-dn on the CLI. Then on inbound within CCA I set the FXO ports to point to operator and the extension of the ephone-dn to point to. Wish I could of done it from CCA so now CCA is not aware of it.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...