Hello. I am new to the UC540 and to SIP. I am trying to route a call to a SIP trunk and I keep getting the SIP/2.0 488 Not Acceptable Here error. I have looked at all cases related to this problem on Google...as well as looking at logs.
I have checked to make sure that my dial-peer has a codec entry and I have checked and re-checked my access-list. I am stuck!
We are using dial-peer 1031. I modified the log to protect the actual number that was called.
I have posted my config and a log of the call...
This below puzzles me the most...why is port 18620 being used? Why is Destn IP Address and Port not populated?
154770: Nov 21 11:07:43.600: //5940/CAC816449341/SIP/Call/sipSPICallInfo: The Call Setup Information is: Call Control Block (CCB) : 0x87DAD098 State of The Call : STATE_DEAD TCP Sockets Used : NO Calling Number : 701854xxxx Called Number : 17014553600 Source IP Address (Sig ): 172.16.69.4 Destn SIP Req Addr:Port : 10.10.201.32:5060 Destn SIP Resp Addr:Port : 10.10.201.32:5060 Destination Name : 10.10.201.32
154771: Nov 21 11:07:43.600: //5940/CAC816449341/SIP/Call/sipSPIMediaCallInfo: Number of Media Streams: 1 Media Stream : 1 Negotiated Codec : No Codec Negotiated Codec Bytes : 0 Nego. Codec payload : 255 (tx), 255 (rx) Negotiated Dtmf-relay : 0 Dtmf-relay Payload : 0 (tx), 0 (rx) Source IP Address (Media): 172.16.69.4 Source IP Port (Media): 18620 Destn IP Address (Media): - Destn IP Port (Media): 0 Orig Destn IP Address:Port (Media): [ - ]:0
I appreciate any tips to get this sorted...because I am so new, this has been very frustrating!
Ok...I worked with the Vendor on this and they indicated they have not tested with the UC540. How can I get a huge volume of logging detail from the UC540 such that I can see if some data being sent to the SIP Trunk is in error?
If I can log both sides at the same time I might be able to pinpoint a problem.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...