is it possible to configure the line buttons taht they are flashing if an other dn is ringing?
example: phone 1 with dn 1 is ringing; phone 2 with dn 2 and dn 1 configured as monitor.
problem: if dn 1 is ringing user 2 with dn 2 dont know if dn 1 is ringing or busy because the monitor button is red in both cases. on cm the monitor button if flashing if another dn is ringing. is this behaviour possible with uc540?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...