Im a newcomer for Cisco VOIP products even though I got some non-Cisco VOIP products experience from my previous job. We would like to integrate our UC560 to customer network which already has dedicated VLANs for data and voice. In order to integrate our UC560 to their existing network , we are required to modify the default VLANS ( 90 , 100) on UC560 . Is there a legal way that we can make it happen ? Are we going to break UC560 if we made this change ?
Please use CCA (Latest revision if possible) to make these changes as it will propagate all the information to their appropriate places.
If my memory services me right, this will be located in the routing draw in the left hand side navigation, you will most likely have to delete the existing entries and recreate a the new one with the settings you wish, and CCA will ensure that the changes are made in all the right locations, it is in this section you also get the ability to change the CUE subnet under that CUE VLAN entry.
Hope this helps...
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Using CCA to change VLAN 90 has never worked for me. I have always had to use CLI. I would recommend you call SBSC and they can help you with this to ensure you remaining within their CCA management rules.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...