So ive turned on the remote login via https on, and as far as i understand i should be able to login via my wan ip address on my uc 320w which is 192.168.1.6, so should i be able to test this internal on the network by using https://192.168.1.6:8080, because it doesnt work, ive also done a port 8080 forward to 192.168.1.6 in my router so i should be able to use https://publc_address:8080.
To confirm your configuration, you have another router sitting WAN side of the UC320W. In that router you have a TCP port forward of WAN router WAN IP to the WAN IP address of the UC320W (a static or DHCP reserved address). It also matters where the PC you are testing the access is located as some routers don't like hairpining traffic on their WAN interface.
The basic test is to connect your PC to the 192.168.1.x network and try to access the UC320W by https://192.168.1.6:8080 If that works, then you need to connect your PC to the the internet (WiFi in a coffee shop, etc) and try to access your WAN router's WAN IP on port 8080.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...