Re: Update UC520-7.0.3 Bug when I upload by interface CCA 2.0
Formatting on the UC500 is fine as well. The key file in allowing the UC500 to boot correctly is the main firmware image - uc500-advipservicesk9-mz.124-20.T2 or similar. If you have that file on the flash card, then the UC500 should boot ok.
Are you saying that when you copied the file across using TFTP, you were only able to transfer 35% of the file? Or is there a different problem.
Can you show me a directory listing of the flash card - taken either from another UC500 or from a PC using a flash reader? Try to ensure that you get the file sizes displayed as well.
If you were having problems copying the file using TFTP for whatever reason, you can copy the files on to the flash card manually using a PC and CF card reader, but as I said, the key file you need is the firmware image. Once you have that, you should be able to use CCA to do a proper firmware upgrade on the UC500 which will make sure all the phone firmware files and the voicemail application files are applied properly.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...