I explain the problem that i have and i am not able to find the solution.
In the central office i have a UC560, we want to connect from a remote office some SPA504 and 7962 phones directly to the UC560, we want that the remote office be as a part of the central office. I understand that we must use a Site to Site VPN.
For the Site to Site VPN we installed a SRP541W in the remote office. I understand that this device is right for this.
Well, the problem is that once installed and configured the SRP541W for the Site to Site VPN, the SRP541W indicates that the VLAN Data is connected, but the rest of VLANs and phones are not connect.
I've done a thousand tests IPSec policies and ACL but i can not find the solution.
Does anyone know or can tell me where i am failing or how i must to configure it?
Data and settings that i configured:
WAN Address xxx.xxx.xxx.1
VLAN DATA (1) 10.14.100.1/24
VLAN VOICE (100) 10.1.20.1/24
VLAN CUE (90) 10.1.10.2/30
WAN Address xxx.xxx.xxx.2
VLAN DATA (1) 10.24.10.1/24 DHCP Data 10.24.10.0/24
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...