Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WAN Port Full Duplex

I have connected my UC540 latest software pack to a FIOS Box. i'm only getting half the speed.

Can someone post the steps on CLI to make the WAN interface full duplex please?

Everyone's tags (3)
2 REPLIES
New Member

WAN Port Full Duplex

hi there,

this should do the trick

!

conf t

!

interface GigabitEthernet0/0

speed 100

duplex full

!

end

!

wr mem

!

New Member

WAN Port Full Duplex

It would be `interface FastEthernet0/0` for a UC540 actually.

In any case, I believe they are set to "auto" by default... which should have chosen full duplex.

From his description it sounds more likely that he has a throughput problem than a half-duplex issue.

How fast is your FIOS connection? The UC500's aren't really designed for very high speed WANs.

The other thing to check would be traffic shaping settings, if misconfiged, they could certainly limit your speed.

Dan

Please rate useful posts.

482
Views
0
Helpful
2
Replies
CreatePlease to create content