I am a problems with one WIP310v2. If i start the phone the screen appear with cisco logo and two waves and nothing more. I have remove battery and reinsert therefore restart the phone but nothing change.
if I waited for also 2 hours he does not change nothing.
Since your WIP310 is not booting past the Cisco load screen you may have a defective device. Has it done this from the beginning or did it start doing this after it was configured? You may need to give the Small Business Support Center a call so that we can open a case for you. Please find the number listed in the link below for your location.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...