WoL a computer when a spa 504g4 device is attached
I´ve purchased two week ago more than 5x spa 504 g4 devices... Before that, I could WoL my computers using a wol software. I installed the spa device as a switch, a network wire for the phone and, the computer, connected directly to the phone.
After that, I couldn´t WoL my computers. I use the CCGetMAC software.
What can I do? Do I need to change the software? There are no more wire config possibilities.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...