Boa Noite Rodrigo, será que consegue me ajudar novamente?
Tenho um router 2911 com uma PVDM3-16 e 15 canais com a publica, sendo assim sem recursos de DPS para conferencias. Adquiri uma PVDM3-64 para aumentar os recurso de DSPs e possibilitar as conferencias. Inseri a PVDM, configurei a controller, as DSPfarm, porém quando tento montar uma conferencia a ligação cai, consegue me ajudar e verificar o que estou fazendo de errado? As CFB, Trasncode e MTP estão registradas no meu CUCM 10.5.
Abaixo algumas configurações do meu router.
card type e1 0 0
!
network-clock-participate wic 0
network-clock-select 1 E1 0/0/0
!
!
!
trunk group PSTN
hunt-scheme sequential
!
voice-card 0
dspfarm
dsp services dspfarm
!
voice translation-rule 1
rule 1 /\(^4...$\)/ /3222\1/
rule 2 /\(^3...$\)/ /3333\1/
!
!
voice translation-profile Out-PSTN
translate calling 1
!
!
license udi pid CISCO2911BR-V/K9 sn TSP1926ABND
hw-module pvdm 0/0
!
hw-module pvdm 0/1
!
controller E1 0/0/0
framing NO-CRC4
line-termination 75-ohm
ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
cas-custom 0
country brazil
category 2
answer-signal group-b 1
trunk-group PSTN
!
!
voice-port 0/0/0:0
!
!
sccp local Loopback0
sccp ccm 10.1.10.12 identifier 3 priority 3 version 7.0
sccp ccm 10.1.10.10 identifier 1 priority 1 version 7.0
sccp ccm 10.1.10.11 identifier 2 priority 2 version 7.0
sccp
!
sccp ccm group 1
bind interface Loopback0
associate ccm 1 priority 1
associate ccm 2 priority 2
associate ccm 3 priority 3
associate profile 31 register MT2-GW1
associate profile 21 register MT1-GW1
associate profile 1 register XCD-GW1
associate profile 11 register CFB-GW1
keepalive retries 5
switchover method immediate
!
dspfarm profile 1 transcode
description Transcoding DSPs
codec g729r8
codec g711alaw
codec g711ulaw
maximum sessions 2
associate application SCCP
!
dspfarm profile 11 conference
description Conferencing DSPs
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
codec g722-64
maximum sessions 8
associate application SCCP
!
dspfarm profile 21 mtp
description G711 Software DSPs
codec g711ulaw
maximum sessions software 100
associate application SCCP
!
dspfarm profile 31 mtp
description G729 Software DSPs
codec g729r8
maximum sessions software 100
associate application SCCP
!
!
!
!
router01#SH VOICE DSP GROUP ALL
DSP groups on slot 0:
dsp 1:
State: UP, firmware: 26.8.4
Max signal/voice channel: 32/32
Max credits: 480
num_of_sig_chnls_allocated: 30
Transcoding channels allocated: 0
Group: FLEX_GROUP_VOICE, complexity: FLEX
Shared credits: 480, reserved credits: 0
Signaling channels allocated: 30
Voice channels allocated: 0
Credits used (rounded-up): 0
Slot: 0
Device idx: 0
PVDM Slot: 0
Dsp Type: SP2600
dsp 2:
State: UP, firmware: 26.8.4
Max signal/voice channel: 32/32
Max credits: 480
num_of_sig_chnls_allocated: 31
Transcoding channels allocated: 2
Group: FLEX_GROUP_VOICE, complexity: FLEX
Shared credits: 27, reserved credits: 0
Signaling channels allocated: 0
Voice channels allocated: 0
Credits used (rounded-up): 0
Group: FLEX_GROUP_XCODE, complexity: HIGH
Shared credits: 0, reserved credits: 69
Transcoding channels allocated: 0
Credits used (rounded-up): 0
Group: FLEX_GROUP_CONF, complexity: CONFERENCE
Shared credits: 0, reserved credits: 384
Codec: CONF_G722, maximum participants: 8
Sessions per dsp: 5
Slot: 0
Device idx: 0
PVDM Slot: 0
Dsp Type: SP2600
dsp 7:
State: UP, firmware: 26.8.4
Max signal/voice channel: 16/16
Max credits: 240
num_of_sig_chnls_allocated: 16
Transcoding channels allocated: 0
Group: FLEX_GROUP_CONF, complexity: CONFERENCE
Shared credits: 0, reserved credits: 240
Codec: CONF_G722, maximum participants: 8
Sessions per dsp: 4
Slot: 0
Device idx: 0
PVDM Slot: 1
Dsp Type: SP2600
DSP groups on slot 1:
This command is not applicable to slot 1
0 DSP resource allocation failure
Obrigado,
Leandro
