I've got the EasyVPN client configured on an 1841 and the tunnel is up and working with Split Tunneling. I'm able to ping out to the Internet, but I am not able to get any traffic to pass through the tunnel. Are there any debug commands I can use to see where or why the traffic is not passing through the tunnel?
As an update, I have disabled split-tunnelling on my ASA server and reset the remote client. The tunnel is correctly built, I am able to ping to the Internet, however I am still not able to reach any device on the inside of the ASA server.
Another update. I did an extended ping from the inside interface out to a public IP address and it failed. By watching 'sh crypto engine connections active' I can see that the packets were encrypted but never decrypted.
Unfortunately I have too much traffic already flowing across my ASA server to do the same there to see if the packets are being decrypted.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...