Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2 ports for stateful failover

Is there a need to dedicate 2 ports on the ASA to allow for a stateful failover?

According to this, the answer is yes:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml#lanbas

I recall configuring this with only one port.

1 REPLY
Hall of Fame Super Blue

Re: 2 ports for stateful failover

Ron

No you don't have to. If you read the section following the diagram in the link you posted you will see that you can use the same link for both LAN and state failover.

Jon

113
Views
0
Helpful
1
Replies