just configuring a CISCO1812 for a remote location. Connect to the central location is via VPN-Tunnel LAN-to-LAN terminated by a Concentrator. This works very well. Clients with personal computers connected to the switch-ports of the router are authenticated with 802.1x and PEAP using an ACS-Server.
Now I'm looking for the best solution to connect non-802.1x clients (Printer etc.).
I've read tons of documents, some of them stating, the ACS should contain a user with mac-address of the non-802.1x client. But I never see a packet arriving on the ACS-Server form this clients. Debug on the router shows that dot1.x is waiting for EAPOL messages from the client.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...