Solved: Re: 881 - isakmp crypto module not available

chaordixinc · ‎08-22-2012

Hi.

I have a Cisco 881 ISR (CISCO881-SEC-K9) and have the advanced security license installed and enabled/active and in use (see screenshot). However, the isakmp crypto module is not available.

cisco#crypto ?

gdoi GDOI related commands

ipsec IPSec

key Key related commands.

pki Public Key

Here's my output of "show version"

Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 15.0(1)M8, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Thu 16-Feb-12 02:58 by prod_rel_team

ROM: System Bootstrap, Version 12.4(22r)YB5, RELEASE SOFTWARE (fc1)

cisco uptime is 11 minutes

System returned to ROM by reload at 13:47:55 PCTime Wed Aug 22 2012

System restarted at 13:48:27 PCTime Wed Aug 22 2012

System image file is "flash:c880data-universalk9-mz.150-1.M8.bin"

Last reload type: Normal Reload

Last reload reason: Reload Command

This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to

export@cisco.com.

Cisco 881 (MPC8300) processor (revision 1.0) with 236544K/25600K bytes of memory.

Processor board ID FTX1624812T

5 FastEthernet interfaces

1 Virtual Private Network (VPN) Module

256K bytes of non-volatile configuration memory.

125440K bytes of ATA CompactFlash (Read/Write)

License Info:

License UDI:

-------------------------------------------------

Device# PID SN

-------------------------------------------------

*0 CISCO881-SEC-K9 FTX1624812T

License Information for 'c880-data'

License Level: advsecurity Type: Permanent

Next reboot license Level: advsecurity

Configuration register is 0x2102

Karsten Iwen · ‎08-22-2012

What kind of module are you missing? Or are you missing the command "crypto isakmp" which is not available in your printout?

If it's just the command, then go to conf-mode where you can configure isakmp and find the "crypto isakmp ..." commands.

Sent from Cisco Technical Support iPad App

View solution in original post

Karsten Iwen · ‎08-22-2012

What kind of module are you missing? Or are you missing the command "crypto isakmp" which is not available in your printout?

If it's just the command, then go to conf-mode where you can configure isakmp and find the "crypto isakmp ..." commands.

Sent from Cisco Technical Support iPad App

chaordixinc · ‎08-23-2012

Hi Karsten.

User error, just as I figured. I needed to be in "config" mode to do the setup, and it's working now (well, mostly, I have a routing issue, but that's another thing completely).

Todd