Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

A beginner with problems

I have used the ASDM to configure my ASA5520. I used the Startup Wizard to setup my interfaces and other basic options. When I started testing none of the hosts in either of the inside interfaces could get it the Internet. I was also unable to get hosts on both inside networks to connect to each other. I has able to ping host on both inside interfaces from the ASA. I have attached my config. Any help would be greatly appreciated.

thanks

Matt

3 REPLIES
New Member

Re: A beginner with problems

You need to define your default route to your next hop router.

route outside 0 0 x.x.x.x

New Member

Re: A beginner with problems

imanl,

Thank you for your comments.

Would adding that route also solve the hosts on the two inside networks not connecting to each other?

Matt

New Member

Re: A beginner with problems

the default route is only to access traffic from in to out. if you have the same security level, you only need "same-security-traffic permit inter-interface"

intra-interface is for traffic protected with IPSec. unless you are using IPSec, remove this command.

155
Views
0
Helpful
3
Replies