Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Access VPN after new rsa key

I changed the hostname on my 506(6.3) and so had to generate a new rsa key. Now clients are unable to connect using their access-vpn's. I suspect this is due to the rekey but I thought the clients would automatically accept the new key being provided. What do I need to do to get the clients access?

1 REPLY
Anonymous
N/A

Re: Access VPN after new rsa key

RSA Key

The setup process generates an RSA key automatically. To generate an RSA key manually, follow these steps:

--------------------------------------------------------------------------------

Step 1 Enter configuration mode:

pixfirewall# configure terminal

Step 2 Remove the existing RSA key, if applicable:

pixfirewall (config)# ca zeroize rsa

Step 3 Generate a new RSA key:

pixfirewall (config)# ca generate rsa key 512

249
Views
0
Helpful
1
Replies
CreatePlease to create content