Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACS interface level command

Hi all,

how do we give only interface level config command access and show commands for usergroup.

Thanks in advance.

Rgds,

Rajesh

1 REPLY
New Member

Re: ACS interface level command

TACACS+ Settings section permits you to enable and configure the service/protocol parameters to be applied for the authorization of a user.For more informartion

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_user_guide_chapter09186a0080204d46.html#wp595758

111
Views
0
Helpful
1
Replies