I have a strange issue with anyconnect. Anyconnect is based on radius credientials. When I login through portal it's working correctly, I can connect to vpn without any problems. But when I want to connect directly from anyconnect client it asking for credentials and don't want to connect. Credientials arfe valid.
[2014-10-23 13:04:02] Ready to connect. [2014-10-23 13:06:20] Contacting 220.127.116.11. [2014-10-23 13:06:45] Please enter your username and password. [2014-10-23 13:06:53] User credentials entered. [2014-10-23 13:07:28] Please enter your username and password. [2014-10-23 13:22:55] User credentials entered. [2014-10-23 13:23:49] Please enter your username and password. [2014-10-23 13:23:55] User credentials prompt cancelled. [2014-10-23 13:23:55] Ready to connect.
What could cause this issue, do I missed something in configuration?
I was actually asking for the full running configuration of the ASA.
This is only part of the config. This is why Clientless VPN works:
webvpn context webvpn
aaa authentication list ciscocp_vpn_xauth_ml_1
As I posted above, you need to have the same aaa authentication command under the tunnel group (connection profile) for the anyconnect vpn.
Please remember to select a correct answer and rate helpful posts
Please remember to rate and select a correct answer
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...