AnyConnect Mobility Client disconnecting after logon
We are using AnyConnect 3.0.5075 (though it happens in earlier versions), when a user logons on to the corporate wireless, the device will connect to authenticate, then disconnects for 30 seconds and then reconnects. The VPN side of the software is disabled and does not show under the AnyConnect client, the NAM module is configured via the Windows profile editor.
It's not happening with all Wifi cards, only with the Centrino Advanced-N 6230.
The main problem is the network drops when the logon scripts are running at the point it tries to map the corporate filestore drive.
In Windows event log I get the following error
Log Name: Cisco AnyConnect Secure Mobility Client
Task Category: Engineering Debug
Network accessible. Retesting connectivity to the secure gateway in 30 seconds
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...