When I attempt to install the Anyconnect client I get an entry in my task manager that says "A SmartNET contract is required for support - Cisco AnyConect Secure Mobility Client." And the install stops.
I have all of the contracts I need - what am I missing?
I am trying to work through the licensing side with Cisco. I had the AnyConnect client downloaded and working. Then my client would not connect. So I uninstalled it and attempted to download it again - then I got this message in Task Manager. I have even attempted to install the client from someone else's downloaded version - could it be an issue with my laptop? Stupid question?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...