Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AnyConnect VPN IP settings

 

Hi Experts, I can now connect to my RA VPN however, when I checked my default gateway settings via cmd, I've got the second available ip in my ip pool. Is that normal? Is the RA VPN needs to have default gateway? Thanks, niks

 

 

1 REPLY

AnyConnect uses a point-to

AnyConnect uses a point-to-point tunnel interface to establish the connection, so your gateway address for secured routes is going to be the same as your assigned address. This is normal.

To give you an example, I have connected to my own AnyConnect router and received IPv4 address 172.31.4.11. When I do a "netstat -rn" and check the gateway for my secured routes, I get the following:

Internet:
Destination        Gateway            Flags        Refs      Use   Netif Expire
172.23/22          172.23.4.11        UGSc            0        0   utun0
172.23.4/24        172.23.4.11        UGSc            0        0   utun0

As you can see, the gateway for my secured routes matches my assigned IPv4 address.

36
Views
0
Helpful
1
Replies