Anyconnect VPN on ASA 5505

[Tobi]

Hi,

I configured a Anyconnect VPN on an ASA 5505. Now when i try to connect with an Anyconnect Client i receive the message "User not authenticated" with an older Anyconnect Version (3.0) or just "Ready to connect" after a short attempt to connect.

On the ASA 5505 log i can see this:

So the user seems to be authenticated but the connection is terminated immediately after it is established. Any hints why this could happen? I attached an anonymized config.

Thanks in advance!

Tobias

[Tobi]

No ideas? Or any steps to narrow the problem down?

Another issue is the Webportal, i can access the first page by https://externalIP and after that the https://externalIP/

+CSCOE+/logon.html page cannot be found.

The ASA was reset to factory defaults, only basic config (IP, users, certifcate) and the Anyconnect VPN...

Regards

Tobias