Appending a port # to Cisco Anyconnect SSL VPN client
I have an SSL VPN currently working on an ASA 5505 with the latest software. The ASA pushes the AnyConnect VPN Client automatically. As we have only one public IP address, I had to use it for everything. I have Outlook Web Access running on 443 and the SSL VPN running on 4443. The problem I am having is that the Cisco AnyConnect VPN Client never remembers the FQDN+port number for future connects. Users have to start Cisco AnyConnect VPN Client and edit the Connect to field, putting :4443 at the end of the FQDN. Is there a way to get the client to "remember" the non-standard port number? I figured it would be easier putting the SSL VPN on a different port rather that Outlook Web Access.
Re: Appending a port # to Cisco Anyconnect SSL VPN client
You can configure an AnyConnect XML profile with a host entry that corresponds to the FQDN or IP with the non-standard port appended. This will then be used to prepopulate the Connect To field. You can read more about AnyConnect profiles at the link below.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...