12-05-2011 01:09 AM
Hello
i have cisco 5505 and i confirgured a remote VPN clients. here is my sceniro
cisco switch 2950 === holds two private network 192.168.8.x and 192.168.4.x
vlan 2 outside interface - Eth0/0 155.155.155.x
Vlan 1 inside interface -- Eth 0/1 192.168.8.180
VPN pool ip address = 192.168.8.100 --110
i drag i cable from my cisco switch and put in to Eth0/1. and i want to access this twor private networks 192.168.4.x and 192.168.8.x .
now i can access to 192.168.8.x .
but i can't access 192.168.4.x .. please can any one help me that.
Regards
Thomas
12-05-2011 06:50 AM
configure a split tunnel list that contains the networks you want the client to access.
Sent from Cisco Technical Support iPad App
12-06-2011 06:50 AM
please can you refer me a helpfull link .. still it's not working
12-06-2011 07:46 AM
use you favourite search engine and search for " Cisco split tunnelling"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: