Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ASA 5510 Configuration

Hi,

I'm trying to configure a new ASA 5510, the show version output show the activation key being used is not valid. Also I'm not able to perform the "setup" command too....Im getting the follwoing error...

ciscoasa(config)# setup

No inside interface. Can not continue.

ciscoasa(config)#

The show version output displays the following message...

"The Running Activation Key is not valid, using default settings:"

Can someone guide me to solve this problem.

Regards

1 REPLY
Cisco Employee

Re: ASA 5510 Configuration

Look at the command reference:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/cref_txt/s.htm#wp1499159

"Before you can use the setup command, you must have an inside interface already configured."

Commands to configure inside interface

interface

nameif inside

no shut

http://www.cisco.com/en/US/products/ps6120/products_quick_start09186a00803eaf00.html#wp33295

Seems like your Activation key is having some problems. You might want to contact Cisco and make sure the activation key is correct.

You would need to provide the serial number of the unit.

Rate this post if it helps.

Cheers

Gilbert

1246
Views
4
Helpful
1
Replies
CreatePlease to create content